Take photos of all (4) sides of the trailer and the plug for the final walkthrough form and submit the form for the lockbox code.
Enter the code provided via text after submitting the form.
Unlock the ball lock and latch lock, storing the ball lock in the toolbox. Hold on the latch lock.
Raise or lower the jack to the prover elevation of the hitch by using the crank, and lower the trailer onto the ball. Move the pin to the lower hole to fully retract the foot.
Flip the coupler latch back down and re-install the latch lock.
Hook the chains AND the emergency brake cable to the hitch receiver system on the tow vehicle.
Plug in the wire harness and test the running light, brakes, and turn signals.
Make sure the wire harness is not is not in danger for dragging.
Send photos of your haul for marketing!
Un-lock the latch lock and flip the latch up.
Lower the jack foot to the 2nd to bottom hole, use the hand crank to lower the jack the rest of the way down.
Un-hook the chains and emergency brake cable and place them on the frame.
Un-plug the wire harness and coil it around the jack.
Ensure all the contents in the toolbox are placed back neatly.
Install the ball lock and latch lock.
Send a few photos to my cell number (623)-343-6010.
Locate the black controller in the toolbox.
Plug the controller into the top passenger side of the winch.
Remote ON/OFF Switch needs to stay on "OFF".
Pull the cable out by rotating the silver handle to "FREE SPOOL".
Once you are ready to use the winch, turn the silver handle to "Engage".
Ensure the cable is tight, removing slack before pulling the load onto the trailer.
This trailer is supplied with axel/ratchet straps. Below are written instructions for using these straps.
Position the Vehicle Properly:
Drive the vehicle onto the trailer, ensuring it is centered over the trailer axles for proper weight distribution.
Engage the parking brake and place the vehicle in park (or in gear for a manual transmission).
Inspect the Axle Straps:
Check the straps for any damage, such as fraying or cuts.
Ensure the D-rings or loops on the axle straps are intact and secure.
Locate the Anchor Points on the Vehicle:
Identify a solid part of the vehicle’s axle or frame to loop the straps around.
Avoid brake lines, wiring, or other sensitive components.
Wrap the Axle Strap Around the Axle:
Place the strap around the axle or approved anchor point.
Ensure the strap is flat and not twisted for maximum strength.
Attach the Strap to the Ratchet Hook:
Secure one end of the axle strap to the hook of the ratchet strap.
Connect the other end of the ratchet strap to the trailer’s anchor point, such as a D-ring or stake pocket.
Position the Ratchet Mechanism:
Place the ratchet mechanism in an accessible location, ensuring it is aligned with the strap for even tension.
Tighten the Strap:
Use the ratchet mechanism to tighten the strap until the vehicle is secure.
Avoid overtightening to prevent damage to the axle or straps.
Repeat for All Securing Points:
Use at least two axle straps (preferably four) to secure the front and rear of the vehicle.
Ensure all straps are evenly tightened for stability.
Perform a Final Check:
Inspect each strap to confirm they are secure and properly aligned.
Shake the vehicle slightly to ensure it is immobilized.
Secure Loose Strap Ends:
Tie off or tuck loose strap ends to prevent flapping during transit.
Stop periodically during transport to inspect and retighten straps as needed.
Using the Lockbox
Hooking Up